USBCNC-FAD - Calmotion

Go to content

Main menu:

USBCNC-FAD

USB to CNC
• Help menu with list of USBCNC-FAD commands
• USB directory listing
• DNC (drip feed) operation
• Mid-tape start capability
• Baud rate configurable
• Punch tooling and data to USB
• Punch tooling data only
• Punch current program
• Punch all programs from CNC to USB key
• Punch machine parameters
• Punch machine survey data
• Tape input for file loading into CNC memory
• File preview command
• Delete files from USB flash key

USBCNC-FAD

Portable USB controller for legacy Fadal CNC's

$ 599.00 Add
Product Description

The USBCNC-FAD disk reader control acts as a portable interface between commercially available USB flash memory and any Fadal control using the RS-232 port located at the rear of the machine. USB connectivity can be achieved any version of Fadal software. Baud rate changes accommodate older machines with -2 systems as well as faster baud rates for -3 and later versions. Neither software nor hardware upgrades are required on the CNC to run large files from a USB flash key. For permanently mounted applications, the USBCNC-FAD-INT is recommended.

USB installation can be achieved in minutes by performing the following steps:
1. Connect both sides of the DB25 serial cable between the USBCNC-FAD and the serial port of the Fadal CNC.
2. Connect the supplied 5V power supply to an AC power wall outlet.
3. Insert a USB key.
Commands for the USBCNC-FAD follow the standard Fadal command set. The “+” key is pressed instead of the enter key to direct the USBCNC-FAD to take action.
Example: Loads file from a USB key called into JOB1.TXT into CNC memory

ENTER NEXT COMMAND CD,10

ENTER NEXT COMMAND TA,JOB1.TXT+
Standard Hardware Includes:
• 2GB USB flash key included with every unit. USB flash keys of any size can be used.
• A 25 foot DB25 cable
• Wall plug regulated 5V power supply
• Machine magnet with USBCNC-FAD command set
 
Back to content | Back to main menu