Glentek motors and amps

The AMP-00xxC AC amplifier uses seven segment display to indicate status. This will give the status of the amplifier. After machine reports and amplifier fault, read the status for the reason the amplifier pulled the the fault line is down. (note, this is for the Calmotion "C" version amplifier, th

The AC amplifier uses 3 wires at power on to determine the initial position of the motor. Once the motor rotates, the amplifier will not use the commutation/hall tracks anymore. So, this error will only occur at power on and when the motor initially begins to rotate. Below are some suggestions to de

The CalAmp-1 AC amplifier uses 2 LEDS to indicate status. One is red the other is green. See below for the location on the amplifier and blinking codes table. This will give you status of the amplifier. After machine reports and amplifier fault, read the status for the reason the amplifier pulled t

The Calmotion CALAMP-7 spindle drive will replace any horsepower drive that powers a Fadal spindle motor*. Whether the spindle motor has an encoder or not as well as supporting rigid tapping option on the machine. The CALAMP-7 is a drop in replacement for inverters and vector drives from Baldor, AMC